 |
Certification and Qualification Gigabit Ethernet Tester for optical & copper CAT5e/ CAT6 network & cablesDeviser - TC701+FC1 platformIncludes FC1 modular platform Deviser equipped with TC701 gigabit Ethernet module. More images:
    |
Price: 3,624.35 EURO *) VAT not included Availability : On demand |
Technical Specification
Optical Interface
2 SFP interface, support 100M and GigE
Available wavelength 850nm, 1310nm and 1550nm
| 100Base-LX | 1000Base-SX | 1000Base-LX | 1000Base-ZX | |
| Wavelength (nm) | 1310 | 850 | 1310 | 1550 |
| Tx Level (dBm) | -15 ~ -8 | -9 ~ -3 | -9 ~ -3 | 0 ~ +5 |
| Rx Level Sensitivity (dBm) | -28 | -20 | -22 | -22 |
| Transmission Distance | 15 Km | 550 m | 10 Km | 80 Km |
| Transmission Bit Rate (Gbit/s) | 0.125 | 1.25 | 1.25 | 1.25 |
| Receiving Bit Rate (Gbit/s) | 0.125 | 1.25 | 1.25 | 1.25 |
| Tx Working Wavelength Range (nm) | 1261 ~ 1360 | 830 ~ 860 | 1270 ~ 1360 | 1540 ~ 1570 |
Measurement Accuracy
| Frequency (ppm): | ±4.6 | ±4.6 | ±4.6 | ±4.6 |
| Optical Power (dB): | ±2 | ±2 | ±2 | ±2 |
| Jitter Compliance: | IEEE802.3 | IEEE802.3 | IEEE802.3 | IEEE802.3 |
| Ethernet Category: | IEEE802.3 | IEEE802.3 | IEEE802.3 | IEEE802.3 |
| Connector: | LC | LC | LC | LC |
| Transceiver Category: | SFP | SFP | SFP | SFP |
Electric Interface
2 ports: 10/100/1000 Bas-T full duplexing
Automatic or manual detecting through/crossover cable
|
|
10Base-T | 100Base-T | 1000Base-T |
| Tx Bit Rate: | 10Mbit/s | 125Mbit/s | 1Gbit/s |
| Tx Accuracy (ppm): | ±4.6 | ±4.6 | ±4.6 |
| Rx Bit Rate: | 10Mbit/s | 125Mbit/s | 1Gbit/s |
| Rx Measure Accuracy (ppm): | ±4.6 | ±4.6 | ±4.6 |
| Duplex Mode: | Half duplex and full duplex | Half duplex and full duplex | Full duplex |
| Jitter Compliance: | IEEE802.3 | IEEE802.3 | IEEE802.3 |
| Connector: | RJ-45 | RJ-45 | RJ-45 |
| Max Distance (m): | 100 | 100 | 100 |
General Specification
| Dimension: | (H x W x D ) 252 x 184 x 76 (mm) |
| Weight (with battery): | 0.35kg |
| Operating Temperature: | 0℃~50℃ |
| Store Temperature: | -40℃~70℃ |
| Relative Humidity: | 0% ~ 95% (non-condensation) |
| Working Time: | Over 4 hours |
| Charging Time: | 5 hours from full discharge to full charge |
| Language: | Chinese, English |
Test Function
| Y. 1564 |
Network configuration and service test on the basis of ITU-T Y.156sam standard, obtain the bidirectional test result by remote loopback and double test equipment mode |
| RFC2544 |
Throughput, Back-to-Back, lost rate and latency on the basis of RFC2544 Frame size: defined by RFC, 1-7 sizes configured by the user |
|
Stream generation and detection |
Generate bit stream and detect Ethernet and IP stream, clarify and count according to different conditions |
| Multi Stream |
Generate and monitor upmost 10 data stream on Ethernet and IP network. Kinds of configured data stream analysis, set packet size, MAC source address/destination address, VLAN ID, VLAN priority, IP source address/destination address, UDP source/destination port and payload |
| Through Mode | Section the data stream between service provider’s network and user’s equipment |
| BER Test | Supports the BER test of up to 4 layers |
| Pattern (BERT) |
PRBS 2E7-1, PRBS 2E9-1, PRBS 2E11-1, PRBS 2E15-1, PRBS 2E20-1, PRBS 2E23-1, PRBS 2E29-1, PRBS 2E31-1, and a pattern defined by the user. Supports reversal pattern |
| Error Test (BERT) | Bit error, mismatch 0, mismatch 1 |
|
Frame Statistics and Analysis |
overrun/maximum, minimum, undersize, FCS, symbol, alignment, conflict |
| Warning Monitor | LOS, link disconnection |
| VLAN Support |
At most two layers VLAN data stream are generated by VLAN ID or VLAN priority on any stackable VLAN layers |
|
Service Discontinued Time (SDT) |
Includes statistic data, such as the longest discontinued time, shortest discontinued time, last discontinued time, average discontinued time, counting, total discontinued time |
| IPV6 | Supports BERT, RFC2544, data stream generating and detecting, PING, Traceroute |
Others
| Optical Power Measurement | Supports optical power test, result displayed by dBm |
| Remote/intelligent Loopback | Supports equipment to find and set loopback mode automatically |
| Dual Test Set Mode | Supports bidirectional RFC2544 and Y.1564 test |
| Save and Load Configuration | Supports USB device and flash memory to save/load test configuration |
| IP Tool | PING, TRACEROUTE, LIBPCAP |
| Event Record | Supports test result records including date, time, detailed information |
| Report Generation | Generate and output test report on the equipment |
| Remote Control | Supports browser visit/control |